You are here:

Brightness Control Mode

 

To enter the brightness control mode, make sure to have at least one Lighting Arm plugged in.

 

Press the top button once, this will activate brightness control mode. One Lighting Arm will begin to pulse, indicating that this arm is being adjusted. If you have a Flash Lighting Arm plugged in, the green and red indicators will flash on and off.

 

Brightness control mode will end after a few seconds of inactivity, returning the pod to normal operation and saving the brightness settings for each arm.

Control Pod

Adjusting Brightness

While in brightness control mode (pulsing arm) you can hold either the + or – button to adjust the brightness of the pulsing arm. If adjusting a Flash Lighting Arm, the same operation will adjust the power level which is set by the 5 LEDs.

 

When holding + or -, the arm will stop pulsing to show the current brightness. For a Flash Arm you will be able to see the 5 red power indicator LEDs go up and down as you adjust the Arm. The arm indicators/LED will flash when either maximum or minimum brightness is achieved.

 

When the brightness is set, either press the top button to move to the next arm or leave the pod for a few seconds to save the new brightness/power settings.

Control Pod Controls
Control Pod Controls

Additional Resources

 

Adaptalux Studio information:ย Adaptalux Lighting Studio

Video Demo and Tutorials –ย Adaptalux Studio Demo

Table of Contents